Hobie Cat Forums

It is currently Thu Apr 17, 2014 8:50 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Aug 19, 2010 9:52 am 
Offline
Site Rank - Old Salt

Joined: Fri Dec 28, 2007 11:23 am
Posts: 506
Location: Lake Norman NC
This is a question for Hobie Matt
I have trailered large and wide the last few years with no problems
This has cut set up and take down time in half
I do need one oversize pin for sure and maybe two oversize pins
What about drilling a oversize hole in the frame and placing a regular SS bolt washer and nut instead of the taper pin which is used for alignment when pulling hulls in and out
I am also thinking about putting epoxy in the frame and bonding everything together
I would leave the pins in place for tramp ties and added strength
Any thoughts

I measured my Hydra Sport 24 side to side it is 2" form Hobie 21SE side to side and I pull it thousands of miles pulling large and wide is the only way to go


Top
 Profile  
 
PostPosted: Thu Sep 09, 2010 3:16 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8604
Location: Oceanside, California
Either or both ideas would work.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
PostPosted: Fri Sep 10, 2010 8:21 am 
Offline
Site Rank - Old Salt

Joined: Fri Dec 28, 2007 11:23 am
Posts: 506
Location: Lake Norman NC
Hobie Matt
Many Thanks I will let all know of results


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group