Hobie Forums
http://www.hobie.com/forums/

Parting out 21SE
http://www.hobie.com/forums/viewtopic.php?f=45&t=41946
Page 1 of 1

Author:  foursail [ Tue Apr 03, 2012 3:32 pm ]
Post subject:  Parting out 21SE

Every thing but mast mainsail and one wing avaiable

Author:  hobie18rich [ Wed Apr 11, 2012 4:02 pm ]
Post subject:  Re: Parting out 21SE

How much for the rear cross beam?
Does it still collapse well?
Where is it located?

Author:  Bill 404 [ Thu Apr 12, 2012 4:29 am ]
Post subject:  Re: Parting out 21SE

Do you have a spinnaker pole?

Author:  foursail [ Fri Apr 13, 2012 9:18 am ]
Post subject:  Re: Parting out 21SE

The rear cross beam is $100 plus shipping from 27964, have sent PM.
There was no spinnaker gear on this boat.

Author:  alomakin [ Tue Apr 17, 2012 8:35 pm ]
Post subject:  Re: Parting out 21SE

Do you have jib sail? Thank you Alex

Author:  de [ Mon Aug 27, 2012 3:13 pm ]
Post subject:  Re: Parting out 21SE

Do you have the jib sheet blocks still ? Are they Harken or the other brand (Seaway?) the SEs first came with ?

Author:  hobie21dan [ Thu Sep 06, 2012 1:42 pm ]
Post subject:  Re: Parting out 21SE

Did you end up selling the rear cross beam to Hobie18Rich? If not would you sell the traveler track? How much?

Author:  KRavEN [ Fri Sep 07, 2012 4:23 am ]
Post subject:  Re: Parting out 21SE

I need some stuff too. Shoot me a PM if you still have anything available.

Author:  Jeff Beckett [ Sat Sep 29, 2012 11:47 am ]
Post subject:  Re: Parting out 21SE

Hello I need a port side hatch cover. Do you still have one available?

Author:  nasamedic [ Wed Oct 31, 2012 6:22 pm ]
Post subject:  Re: Parting out 21SE

Looking for a port hull.
rick
[email protected]

Author:  fastfriend [ Mon Nov 05, 2012 6:01 pm ]
Post subject:  Re: Parting out 21SE

looking for a shroud anchor pin. adams four two nine at yahoo dot com

Author:  foursail [ Tue Nov 13, 2012 6:39 am ]
Post subject:  Re: Parting out 21SE

SOLD SOLD
Boat was sold, only only a port wing available, which could probably be modified to starboard.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/