| Hobie Forums http://www.hobie.com/forums/ |
|
| How do you know if you have V2 Drums and sprockets on i12 http://www.hobie.com/forums/viewtopic.php?f=47&t=24878 |
Page 1 of 1 |
| Author: | FlaDan [ Tue May 18, 2010 11:41 am ] |
| Post subject: | How do you know if you have V2 Drums and sprockets on i12 |
I am getting ready to get a new i12. My dream is go demo next week (question on how comfortable the seat is for this old body) and if is as great as I expect then buy it. How do you know if you have V2 Drums and sprockets on i12 instead of V1 parts? I guess my real question is the i12s coming from the factory fully converted over to the How do you know if you have V2 Drums and sprockets? |
|
| Author: | mmiller [ Tue May 18, 2010 12:21 pm ] |
| Post subject: | Re: How do you know if you have V2 Drums and sprockets on i12 |
We have had "V2" drums for several years and "V2" sprockets for a couple... the inflatables should be fully V2. A V2 sprocket can be recognized by a bit of visable brass at the point where the mast threads in. Check the MirageDrive FAQ: http://www.hobiecat.com/community/viewforum.php?f=60 |
|
| Author: | ddrury [ Tue May 25, 2010 2:08 pm ] |
| Post subject: | Re: How do you know if you have V2 Drums and sprockets on i12 |
I just bought an inflatable i14T and it had V1 sprocket. The boat is a 2008 model. I had to learn this by trial & error because I ordered the wrong turbo fins. If you have the boat, take one fin off (see video for instructions: http://www.graspr.com/videos/Install-Ho ... rbo-Fins-1) and look up into the sprocket to see if there is threading or a set screw. Good luck! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|