| Hobie Forums http://www.hobie.com/forums/ |
|
| Dodger on TI, Measurements? http://www.hobie.com/forums/viewtopic.php?f=69&t=36476 |
Page 1 of 1 |
| Author: | boka1942 [ Thu Jun 30, 2011 3:51 pm ] |
| Post subject: | Dodger on TI, Measurements? |
I am in the process of fitting a dodger at the front cockpit on my TI. It will protect my dog from sweeping waves. As the instructions are for AIs the measurements for the studs do not apply to my TI. Could anyone provide the measurements for the studs. The two at the hatch edge and the two behind the crossbar seem OK as specified in the instructions but the other six studs need measurement from defined points. I would appreciate help as I do not want to redrill. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|