Hobie Forums http://www.hobie.com/forums/ |
|
Tandem Island Furling Modification http://www.hobie.com/forums/viewtopic.php?f=69&t=50481 |
Page 2 of 2 |
Author: | DM06 [ Thu Apr 10, 2014 9:42 am ] |
Post subject: | Re: Tandem Island Furling Modification |
Armada13 wrote: San Antonio, Texas.... Not too far from the Gulf Coast / Padre Island. San Antonio you say?? I'm in SA. You sailing out at Canyon Lake? Have seen one other TI out there on a trailer but they were coming and we were going. |
Author: | Armada13 [ Thu Apr 10, 2014 11:07 am ] |
Post subject: | Re: Tandem Island Furling Modification |
DM06 wrote: Armada13 wrote: San Antonio, Texas.... Not too far from the Gulf Coast / Padre Island. San Antonio you say?? I'm in SA. You sailing out at Canyon Lake? Have seen one other TI out there on a trailer but they were coming and we were going. PM sent |
Author: | daniellow [ Tue Apr 18, 2017 7:12 pm ] |
Post subject: | Re: Tandem Island Furling Modification |
Great set up. I have started doing the same! Any chance you have a picture of the finished project, specifically where did you site fairleads to make to rope direct up to rear crossbar cleat? Thanks! |
Author: | Armada13 [ Wed Apr 19, 2017 10:21 am ] |
Post subject: | Re: Tandem Island Furling Modification |
I have sold the TI but you can source everything you need from Amazon.. Or you can call Austin Kayak and Canoe.. |
Author: | Armada13 [ Wed Apr 19, 2017 10:27 am ] |
Post subject: | Re: Tandem Island Furling Modification |
Just hold the fairlead in place with furling rope through it somewhat taught and find your best angle.. mark & drill it, you may need to use spacers... I can't remember, it's been a long time.. You can use plastic cutting board to make spacers & make sure to Goop everything .. Marine grade.. Hope that helps. |
Page 2 of 2 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |