Aluminum and Carpeted Hakas by Adamek K9 Kayaking
I thought I would share my design for carpeted decks for our 2014 TI.
(6) P21007.5ML 2 x 10 x 7-6 Mill Finish Aluminum Plank ($470 w/S&H) by
http://www.markstaar.com(12) EC-210/WH Aluminum End Cap w/ Rivets by
http://www.markstaar.com(16) CL-STD/WH Clip Set with Hardware by
http://www.markstaar.com(1) 10’ x 6’ 16oz Boat Carpet – Blue ($60) by
http://www.boatcarpetbuys.com(2) Rubber/carpet mats, split to wrap the Aka Bars ($10) by Lowes.
Stainless Hardware:
SS 10 x 24-3/4” Washers, Lock Rings, Nuts, Pan Screws.
SS 10 x 24-1” Washers, Lock Rings, Nuts, Pan Screws
SS 5/16 x 5” Bolts with Washers, Nuts, and Wing Nuts
Kayak Handles – Austin Canoe & Kayak
Pad Eyes – Austin Canoe & Kayak
Cleats – Austin Canoe & Kayak
Weight of each Haka is 45#.
1. Drilled holes and bolted the 2” sides of the planks together.
2. Drilled holes and bolted ½” Aluminum Tube to the underside of the three planks.
3. Wrapped (not glued) the carpet around the deck, and bolted the ends to the returning sides of the planks.
4. Added Pad Eyes, Cleats, and Handles to sides of planks.
5. Slightly bent the end caps, in order to press fit, rubber hammer into place to hold down carpet.
6. Used ½” Aluminum Tube and Plank Hardware, carriage bolts and wingnuts to hold down on Akas.
Video of our first test run at Canyon Lake, Texas... Youtube Link Below...
https://www.youtube.com/watch?v=05EX21lsLKEhttps://www.youtube.com/watch?v=9D903ynzth4Take care,
Boggy.