[quote="mmiller"]We have a tool for the threaded-in fittings shown in the catalog, but not yet produced, but you can use a needle nose pliers. Tips into the recess points and turn. Perhaps add a vise grip to gain the leverage required.
Thanks Matt. Any idea when the tool will be produced. I sent an e-mail into the company about another issue concerning my AI trailer yesterday. I received the saddles today and had to send in another e-mail. I would rather not air this on a public forum at this time. Can you check to see if they received my e-mails? My name is Glenn Gardiner. My e-mail address is glennegardiner@yahoo. My phone number is 919398-1214. I purchased a basic cart, the AI saddles and the tower, which I believe has not yet been manufactured. I will wait till noon Pacific time on Monday, before I go public