Hobie Forums
http://www.hobie.com/forums/

Identify these parts on the new 2012 TI parts package?
http://www.hobie.com/forums/viewtopic.php?f=71&t=42833
Page 1 of 1

Author:  hullman [ Mon May 21, 2012 10:56 pm ]
Post subject:  Identify these parts on the new 2012 TI parts package?

What are these parts used for and in details for installation if possible please?

These parts came inside the plastic bag (2012 TI parts package) which also included the "scupper plug" and the breakaway "Shear Bolt and Nut". Thanks.

Image

Author:  rusty_sojah [ Tue May 22, 2012 9:18 am ]
Post subject:  Re: Identify these parts on the new 2012 TI parts package?

they go on the pedals (down near the gap where the water would splash up when seated properly and in use) and stop water from splashing up into your nutz.

Author:  tonystott [ Tue May 22, 2012 11:11 am ]
Post subject:  Re: Identify these parts on the new 2012 TI parts package?

Many dealers are reluctant to fit these onto Miragedrives as they can make it a bit harder for a newcomer to these drives to fit the drive in the housing without misalignment. Hence they are often supplied loose like that...

Author:  hullman [ Tue May 22, 2012 11:52 am ]
Post subject:  Re: Identify these parts on the new 2012 TI parts package?

Thanks for the information. I see how it works now.

Have any of you put these on your mirage drives already? Do they work well enough or shall I just avoid using them?

Author:  NOHUHU [ Tue May 22, 2012 12:03 pm ]
Post subject:  Re: Identify these parts on the new 2012 TI parts package?

Use em. Water still gets in. Splash and drag are reduced slightly.

Author:  hullman [ Tue May 22, 2012 8:15 pm ]
Post subject:  Re: Identify these parts on the new 2012 TI parts package?

Thanks and I will use them. Putting them on one of my mirages drives tomorrow and going out sailing. Wishing I was sailing in Hawaii though :)

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/