Hobie Forums
http://www.hobie.com/forums/

Mast diameter
http://www.hobie.com/forums/viewtopic.php?f=71&t=43955		 Page 1 of 1
Author:  worldinchaos [ Tue Jul 17, 2012 11:03 pm ]
Post subject:  Mast diameter
Looking to get some info on the Tandem Island, and can't find info through excessive searching:

What diameter (OD) is the TI mast?

Some post indicates 18' 1.75". Is that above hull, or total length including the fitting?

Trying to feel out its application in another area...

Thanks - Peter
Author:  tonystott [ Wed Jul 18, 2012 12:20 am ]
Post subject:  Re: Mast diameter
I believe that is the height (not the diameter) of the mast above water. It better be because I negotiate under a few low bridges round here!
Author:  kayakman7 [ Wed Jul 18, 2012 12:30 pm ]
Post subject:  Re: Mast diameter
worldinchaos wrote:
Looking to get some info on the Tandem Island, and can't find info through excessive searching:

What diameter (OD) is the TI mast?

Some post indicates 18' 1.75". Is that above hull, or total length including the fitting?

Trying to feel out its application in another area...

Thanks - Peter


according to my caliper, the base is 2.086 inches tapering to 1.225 inches at the mast head

j
Author:  kayakman7 [ Wed Jul 18, 2012 12:32 pm ]
Post subject:  Re: Mast diameter
the furling drum and base socket are larger diameter. i only measured the mast.
Author:  worldinchaos [ Wed Jul 18, 2012 2:15 pm ]
Post subject:  Re: Mast diameter
kayakman7 wrote:
the furling drum and base socket are larger diameter. i only measured the mast.


No, no, that's very helpful. I can look at pictures and scale accordingly if I need the diameter of the drum or base socket. Thank you very much. :D
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/