Carl M wrote:
I use the Harken 29c, it's really close but you need to elongate the holes in the block, I used an 1/8" drill bit and drill to do so....
Thanks! That's what I was trolling for...
Looks like Harken=30mm and existing holes = 27mm.... so you elongated one of the Harken holes by 3mm...?
Or did you elongate each hole about 1.5mm?
_________________
2015 AI in "Dune" - "The Grey Pig"
2017 Trailex 450 Trailer
Pre-September 2015 cradles
(anybody want to buy a slightly-used AI SpinKit?)
eMail:
[email protected]