Hobie Forums http://www.hobie.com/forums/ |
|
Yakima rollers http://www.hobie.com/forums/viewtopic.php?f=73&t=49766 |
Page 1 of 1 |
Author: | Vabeach2 [ Fri Nov 08, 2013 1:01 pm ] |
Post subject: | Yakima rollers |
I will be transporting two AIs and will be placing the second on top of a tracRack. The bars are roughly 68" apart. I have two sets of Yakima rollers that I placed on top, however I can't figure out the spacing under the hull. Should they be slanted on the inner slope of the hull I between the scuppers, just outside, or supporting the outer edges. For now, I have the front rollers touching the inner hull, inside of the scuppers and the rear on the outsides. Thank you for any replies. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |