Hobie Forums http://www.hobie.com/forums/ |
|
Stacking an AI on a TI http://www.hobie.com/forums/viewtopic.php?f=73&t=58476 |
Page 1 of 1 |
Author: | quattroguy [ Wed Jul 20, 2016 9:00 am ] |
Post subject: | Stacking an AI on a TI |
Finally getting others in the family into these, now I need to carry both boats to the local lakes. About an hour drive, I would like to put the AI on top of the TI, can make a support to hold the load on the tandem AKA bars, then strap the AI down to the trailer. The AMAs can go in the truck. Is this OK or am I putting too much load on the TI? |
Author: | tonystott [ Wed Jul 20, 2016 4:09 pm ] |
Post subject: | Re: Stacking an AI on a TI |
Firstly, this is purely conjecture on my part, as I have never tried this.. 1) Create as many contact points as you can to avoid any localised high loading (eg, wrap cushions in plastic to go between the hulls) 2) I would suggest you tie the TI to the trailer, and then the AI to the TI, rather than squash them together by trying to use a single set of tie downs. That way, you can apply just enough tension to hod the AI down without crushing the cushioning mentioned in 1) above. My $0.02 |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |