Hobie Cat Forums

It is currently Thu Nov 20, 2014 2:00 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sat Dec 13, 2008 7:17 pm 
Offline
Site Rank - Old Salt

Joined: Sat Nov 29, 2008 7:33 pm
Posts: 305
Location: Coram N.Y.
Thanks Matt - but the molded female cavities on my boat will not fit a longer seat peg. Dont like using glue either as it will break down eventually under harsh conditions. I pressed the pegs in and drilled a hole sideways through each cavity. Then inserted a cotter pin (from Home Depot). Test drove A.I. through rough waters for 2 hours with minimal saturation below deck. Jeff

_________________
New to PCs and this forum stuff. Had an original Outback and Classic. sold them both for the A.I.. Love the boat and especially this site... (if I can figure out how to use it)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: SOCAL TI and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group