Hobie Forums http://www.hobie.com/forums/ |
|
Seat pegs popping out(solution) http://www.hobie.com/forums/viewtopic.php?f=75&t=11368 |
Page 1 of 1 |
Author: | Aledal [ Sat Dec 13, 2008 7:17 pm ] |
Post subject: | Seat pegs popping out(solution) |
Thanks Matt - but the molded female cavities on my boat will not fit a longer seat peg. Dont like using glue either as it will break down eventually under harsh conditions. I pressed the pegs in and drilled a hole sideways through each cavity. Then inserted a cotter pin (from Home Depot). Test drove A.I. through rough waters for 2 hours with minimal saturation below deck. Jeff |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |