Hobie Forums http://www.hobie.com/forums/ |
|
Putting a 07 receiver into a 09 hull http://www.hobie.com/forums/viewtopic.php?f=75&t=11675 |
Page 2 of 2 |
Author: | geocacher [ Sat Jan 31, 2009 3:44 am ] |
Post subject: | |
Not sure about where you are but from most industrial suppliers here you could get a hole saw to make that cut for about AU$35. An arbor would set you back a little more but you would get a perfect hole and the fitting instructions or the factory would be able to tell you exactly what size. My last two 4wd's (Ford Courier & GU Nissan Patrol) I've fitted my own snorkels to them. The dealers or 4wd joints charge about $400 for what is a simple job. It's pretty scary dropping a 100mm plus (4" +) diameter holesaw through your shiny quarter panel (guard). On the Patrol I had to do the outer panel and the inner guard. I know how you felt cutting your AI hull. Dave |
Page 2 of 2 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |