Hobie Cat Forums

It is currently Thu Sep 29, 2016 3:19 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: TI aka pin came loose
PostPosted: Tue Jun 28, 2016 10:57 am 
Offline
Site Rank - Deck Hand

Joined: Wed Jun 01, 2011 7:12 am
Posts: 3
TI owners for about a month

On our trip Sunday my wife (back seat driver!) noticed the rear right aka pin was about an inch out of the joint. The pin was under strain on the water and could not be adjusted.

When we packed up the boat on the trailer the pin slotted back into place.

What is holding the pin(s) in there? Should we be concerned these may fall out of the joint while we're driving and the boat is on the trailer ?

From the 2 diagrams of parts I'm assuming this pin is part # 88991021

http://cdn.hobiecat.com/digital_assets/ ... atalog.pdf
(page 52)
http://static.hobiecat.com/digital_asse ... ts2016.pdf

Thanks for your input

Greg S
North Dallas


Top
 Profile  
 
PostPosted: Tue Jun 28, 2016 1:05 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 11221
Location: Oceanside, California
There is a set screw holding the pin in place. With the akas folded you can see a small square cap at the joint. Pull the cap out. The screw may need a bit of blue loc tite to hold it in. Contact your dealer for help on that if needed.

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
PostPosted: Sat Jul 09, 2016 8:58 am 
Offline
Site Rank - Deck Hand

Joined: Wed Jun 01, 2011 7:12 am
Posts: 3
Thank you Matt, the screw is missing. That explains it!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group