| Hobie Forums http://www.hobie.com/forums/ |
|
| Roller furling collar slipping upward on mast (TI) http://www.hobie.com/forums/viewtopic.php?f=75&t=34816 |
Page 1 of 1 |
| Author: | mkrawats [ Wed Apr 06, 2011 5:30 am ] |
| Post subject: | Roller furling collar slipping upward on mast (TI) |
The roller furling collar appears to be slipping upward on the TI's mast.  These issues were first reported on the Hobie forum in early 2009. http://www.hobiecat.com/forums/viewtopic.php?f=75&t=20914&hilit=mast+furl+glue&start=0 http://www.hobiecat.com/forums/viewtopic.php?f=75&t=13068&p=73301&hilit=mast+collar Is the TI susceptible to this problem too? |
|
| Author: | KayakingBob [ Wed Apr 06, 2011 10:58 am ] |
| Post subject: | Re: Roller furling collar slipping upward on mast (TI) |
One of my AI's masts just starting slipping upward too. |
|
| Author: | mmiller [ Wed Apr 06, 2011 11:20 am ] |
| Post subject: | Re: Roller furling collar slipping upward on mast (TI) |
Quote: Is the TI susceptible to this problem too? If the picture shows a TI mast with a slipped drum... I guess it is. Correction is to re-bond with Epoxy. I'm sure that has been discussed here, so a simply forum search should locate needed info. This would be covered by warranty of course, so a dealer can do it if needed. |
|
| Author: | bosab [ Thu Apr 07, 2011 9:30 pm ] |
| Post subject: | Re: Roller furling collar slipping upward on mast (TI) |
My 2011 TI also had slipped up. In the process of re-epoxy . First clue was the clamp on the boat was not engaging the furling drum without some help. I thought I had lost adjustment in the V bolts but the mast collar had slipped up a 1/4" . |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|