Hobie Forums http://www.hobie.com/forums/ |
|
Trying to replace my fins. http://www.hobie.com/forums/viewtopic.php?f=75&t=43288 |
Page 1 of 1 |
Author: | PedalPower [ Wed Jun 13, 2012 1:15 pm ] |
Post subject: | Trying to replace my fins. |
I have two Hobie Mirage Outbacks that I want to install the Turbo Fins on. I'm trying to determine if I have the V1 or the V2 drives. And local dealers has not been able to tell me. I know from reading the forums that the V1 has a set screw holding the mast and the V2 is a threaded mast. Both of my drives have a cotter pin holding the stainless mast to the drive. Once you remove the cotter pin, the mast comes out. I have followed this forum religiously since owning the Mirages but have not seen this issue being mentioned. Does anybody know which drive or which Turbo fin kit I need? Thanks in advance for the help, |
Author: | KayakingBob [ Wed Jun 13, 2012 1:27 pm ] |
Post subject: | Re: Trying to replace my fins. |
Sounds like you have the original medal (V0?) drive. |
Author: | Jbernier [ Wed Jun 13, 2012 1:36 pm ] |
Post subject: | Re: Trying to replace my fins. |
The V1 Turbo kit will work - it has a slot for the set screw - plus a hole for the cotter pin style (original) No problem |
Author: | PedalPower [ Wed Jun 13, 2012 6:29 pm ] |
Post subject: | Re: Trying to replace my fins. |
Thank you folks for the quick response. I went ahead and order two set of Turbo fins for my Yaks. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |