Hobie Forums http://www.hobie.com/forums/ |
|
Can not Extract Broken Screw Socket/V-Frame Base on AI 2007 http://www.hobie.com/forums/viewtopic.php?f=75&t=46626 |
Page 2 of 2 |
Author: | Herbaldew [ Tue Mar 26, 2013 1:04 pm ] |
Post subject: | Re: Can not Extract Broken Screw Socket/V-Frame Base on AI 2 |
NOHUHU wrote: You should at least retract the turnbuckles and sink the new screw with loctite. You could mark the adjustment location before starting. Maybe a new locknut would be advised too. I can verify this advice as "Excellent" - Thanks! I will add that an offset screwdriver would have been handy. Using an allen wrench to remove the old piece was easy, trying to use a screwdriver to get the new one in was a pain. Not having an offset screwdriver handy, I was able to put a screwdriver in the slot "sideways" to tighten the new screw. |
Page 2 of 2 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |