Hobie Forums
http://www.hobie.com/forums/

Help bent my mast rods on new v2 drive- What type of loctite
http://www.hobie.com/forums/viewtopic.php?f=75&t=47512
Page 1 of 1

Author:  Aud [ Wed May 08, 2013 4:11 pm ]
Post subject:  Help bent my mast rods on new v2 drive- What type of loctite

Managed to get the stainless rods off and straighten them. Not sure what type of loctite to use to put them back in.

Are there written instructions anywhere?

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/