Hobie Cat Forums

It is currently Mon Sep 22, 2014 1:50 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Mon Apr 30, 2007 10:58 am 
Offline
Site Rank - Captain

Joined: Sun Aug 28, 2005 8:13 am
Posts: 136
On Sunday, I was lowering the T&S rudder when the handle came off in my hand. The set screw had worked loose. When that happened, the control arm and spring inside the hull dropped away from the hole they go through to attach to the rudder handle. How do I go about reconnecting the rudder handle to the control arm? Is there an easy way to do this?

Any and all help is appreciated. Thanks in advance.

David


Top
 Profile  
 
 Post subject:
PostPosted: Mon Apr 30, 2007 1:03 pm 
Offline
Authorized Hobie Dealer

Joined: Mon Jun 02, 2003 7:35 pm
Posts: 1370
Location: 315 N. Hwy 79 Panama City Beach, FL 32413 850-235-2281
you crawl inside the kayak and push it back thru the hole, J/K
We replace handles here in the shop with 2 people, one person has to get there arm back in there and hold the control arm out so you can get that handle back on and the set screw in the notch and tighten it down. On the island we use the center hatch to reach the up/down handle.

_________________
Brad Stephens
Brad@sunjammers.com
(866) 786-5266 <--- Advice HOTline
http://www.sunjammers.com
www.facebook.com/sunjammers
Image


Top
 Profile  
 
 Post subject:
PostPosted: Mon Apr 30, 2007 1:46 pm 
Offline
Site Rank - Old Salt

Joined: Fri Jan 05, 2007 9:21 pm
Posts: 2229
Location: Maui, Hawaii
If your boat is an Adventure Island, get the free upgraded handle and inside parts so it won't happen again.


Top
 Profile  
 
 Post subject: Handle
PostPosted: Mon Apr 30, 2007 3:33 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 9025
Location: Oceanside, California
As per the tech bulletin:

Image Up/Down rudder handle - The weight and mass of the larger rudder has caused some rudder control handles to fail. This appears to have been primarily a materials issue with the original handles, but we have taken the issue more seriously and wanted to prevent any similar failures from occurring. Shortly after initial production started, we switched to a through-bolted handle that can absorb many times the expected loads. Some technique is still required to easily raise and lower (see tech notes below). Older handles have a brass insert and set screw. Newer handles have a allen bolt threaded clear through the control arm and into the opposite side of the handle. This update kit includes a new handle, bolt and control arm. This requires re-fitting the control arm and control lines inside the hull. Kit# 81035011

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group