Hobie Forums http://www.hobie.com/forums/ |
|
Hobie Cart in the PA scupper holes http://www.hobie.com/forums/viewtopic.php?f=78&t=16868 |
Page 1 of 1 |
Author: | theblones [ Thu Nov 12, 2009 11:48 am ] |
Post subject: | Hobie Cart in the PA scupper holes |
I just got my PA home and shoved my new style cart (wide but with old style wheels ) and the prongs only just make it through the hole. Not eneough room to thread the new clip through. Am i doing it wrong |
Author: | mmiller [ Thu Nov 12, 2009 12:11 pm ] |
Post subject: | Re: Hobie Cart in the PA scupper holes |
The Trax carts were just long enough, but after a mold change for the hull, not long enough for the keeper pin to work. The newer Trax 2 carts are now longer as is the standard cart. This is a VERY recent change. For your cart... The carts works... the keeper does not. If still new, the dealer may consider a swap. The cart you have works for every other Hobie model. Fyi... The Trax 2 is a bit more expensive. |
Author: | theblones [ Thu Nov 12, 2009 3:24 pm ] |
Post subject: | Re: Hobie Cart in the PA scupper holes |
awww. i used it a few times allready |
Author: | mmiller [ Thu Nov 12, 2009 4:15 pm ] |
Post subject: | Re: Hobie Cart in the PA scupper holes |
You can always ask them. Maybe sell to another Hobie owner? |
Author: | yakkingaway [ Fri Nov 13, 2009 7:40 pm ] |
Post subject: | Re: Hobie Cart in the PA scupper holes |
My cart is the same as yours and I fixed it to work by extending one "leg" of the cart that the pin is on. I found some scrap aluminum that fit rather tight, and jammed it the cart's material. Extended it about two inches maybe and drilled the hole in the new material. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |