Hobie Cat Forums

It is currently Wed Dec 17, 2014 4:12 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
 Post subject: Size of the rear handle?
PostPosted: Mon Jul 19, 2010 1:28 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Jul 18, 2010 8:42 am
Posts: 3
My last post didn't go through for some reason.

I am looking for three measurements of the PA rear handle.

Diameter of the pipe, the length of the exposed pipe and the distance from the handle to the stern of the kayak.

Thank you for your help.


Top
 Profile  
 
PostPosted: Mon Jul 19, 2010 4:32 pm 
Offline
Site Rank - Admiral

Joined: Tue Apr 11, 2006 1:49 am
Posts: 176
It's about 1 1/8 inch tubing, outside dimensions regardless how tubing is measured. The rear handle is just over two inches clearance from the hull. The side handles are just over an inch from the hull.... forgot that dimension. Call it 1 1/8th clearance maybe.

_________________
Yakkingaway
Portsmouth, VA


Top
 Profile  
 
PostPosted: Mon Jul 19, 2010 8:18 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Jul 18, 2010 8:42 am
Posts: 3
Thank you. I'm going to make something to hold the transducer for a fishfinder. This is for a Humminbird 798ci SI so it has to be in the water.


Top
 Profile  
 
PostPosted: Tue Jul 27, 2010 2:19 pm 
Offline
Site Rank - Deck Hand

Joined: Sat Jul 24, 2010 8:42 pm
Posts: 21
Hi, i'm looking at a Liberator transducer mount. It fits on the front board, and will swing up easily when your in shallow water. Someone else here suggested that mount in another post.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: SRAces and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group