Hobie Forums
http://www.hobie.com/forums/

Need some measurements on the stern handle
http://www.hobie.com/forums/viewtopic.php?f=78&t=28037
Page 1 of 1

Author:  Patrick9915 [ Sun Jul 18, 2010 8:52 am ]
Post subject:  Need some measurements on the stern handle

Hey folks, new here. I'm seriously considering the pro-angler as my next kayak and I would like to get some measurements if you would be willing.

There are three dimensions I would like.

1. Outside diameter of the aluminum handle.
2. Length of just the exposed aluminum handle.
3. Distance between the aluminum handle and the hull at the mid point.

Thanks! I'm planning some fabrication for when I get my PA for a fish finder transducer mount and would like to get some ideas flowing. Any help would be appreciated. Thanks again.

Author:  PA-KETTLE [ Tue Jul 27, 2010 2:12 pm ]
Post subject:  Re: Need some measurements on the stern handle

Hi, you want to look up a post here about fish finders. They had a swinging arm that fits on the front board, it can be swung up when you enter shallow water(plus it can be quickly removed.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/