Hobie Forums
http://www.hobie.com/forums/

Lowrance ready feature in PA12 - is it exclusive to Lowrance
http://www.hobie.com/forums/viewtopic.php?f=78&t=42282		 Page 3 of 3
Author:  felvic [ Sat Oct 06, 2012 4:04 am ]
Post subject:  Re: Lowrance ready feature in PA12 - is it exclusive to Lowr
Then I study a simple resolution and which should work correctly.

As I'm sure PEHD lets through waves, I sharpened in an end the same form of the plate of protection Hobie..

Then I embedded well the sonde with the foam high specific gravity so that it does not move in its accommodation, but a little lower than the first try..
Then I heated up with a thermic warmer, PEHD took the form of the transducer:

Image

Then I screwed on screws thoroughly.
So the sonde is protected, both sides are clear and water circulates freely.

Have to see on water but I trust about it...
Author:  felvic [ Sat Oct 20, 2012 2:32 am ]
Post subject:  Re: Lowrance ready feature in PA12 - is it exclusive to Lowr
Try this morning. Very disappointed because it loose more than 50 % of side picture but what I had not realized before, that palms create turbulence and picture is crinkled. :evil:

Therefore for me the transducer hole doesn't fit for Side and Down views (Lowrance structure scan should not work as well).

I turn back and will stuck the transducer on front:

Image
Page 3 of 3 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/