Hobie Cat Forums

It is currently Tue Sep 02, 2014 2:30 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 46 posts ]  Go to page Previous  1, 2, 3, 4
Author Message
PostPosted: Thu Aug 02, 2012 4:59 pm 
Offline
Site Rank - Deck Hand

Joined: Fri Sep 30, 2005 5:45 pm
Posts: 14
Location: los angeles
the clutch rotor on the 35 and 50 cc engines use a 76mm clutch rotor and the smaller 22 thru 30 cc engines use a 54mm clutch rotor. the clutch bell i got from island hopper was out of round and u can see the marks on the inside of the clutch bell where it was hitting and the rest of the bell was not.by using a smaller prop the load on the clutch is much less. if u can get the engine to idle at 2000 rpm or less they have heavy duty clutch shoes that weigh twice as much as the stock shoes and engage at 2000 rpm. these 35cc thru 50cc brushcutters with a saw blade can cut woody stems or small branches up to about an inch and a half to 2 inches in diameter


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 46 posts ]  Go to page Previous  1, 2, 3, 4

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group