Sent from my SCH-I510 using Tapatalk 2
I used PVC conduit to provide support for the hulls. The upper rack are made of 3" conduit cut to a 9ft lenght. I attached them to the after crossbar (above tail gate).
The lower rack is made of 2" PVC conduit to allow more clearance for the lower YAK.
All conduit pipes are spaced 10 inches on center.
The methods I used was found on this forum using tequniques found on varrious trailer topics.
Fishing is not a matter of life or death... It's much more important than that!