I have a Pro Angler 14 a 2013. Just purchased .....not been in the water yet.
I am running my depth finder wires form the lowrance transducer holder, up through and want to use the Thru Hull Plugs. One behind seat and the one on the right side.
It looks like you have to unscrew those from within. Is that correct? Any tricks on reaching the backs of those in order to unscrew the nut? Or is it just a reach thing?
The challenge is having long arms to reach the back rings that thread onto the plugs to remove them and to re-install them. Make sure you take note of putting the cable through the ring, plug etc. all in the right order when you go to run all the cabling...lol. You could end up having re-run it if you don't have everything on your cables and the correct sides of the opening.
The plugs you use for the wires come in various gage sizes and for one or more wires. It's not that difficult to do...just the reach that can be a challenge for some.