Return to Hobie.com
Hobie Forums
It is currently Thu Mar 28, 2024 8:53 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Oct 27, 2013 7:59 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Oct 27, 2013 7:50 pm
Posts: 1
Im trying to rig my 2013 PA14 for bowfishing, what be the best way to put a trolling motor through the mirage drive hole?


Top
 Profile  
 
PostPosted: Mon Oct 28, 2013 6:17 pm 
Offline
Site Rank - Captain

Joined: Mon May 06, 2013 5:00 am
Posts: 90
Tell us a bit more about intended use , environment, depths. If you will be frequenting shallow water, I would recommend side mounting, so you could easily raise and lower it.


Fitting a watersnake t24 motor through the mirage drive hole is a no brainer. Adopting stock plastic mirage hole filler is also easy.


Doing the same with minnkota could be harder, the motor is larger and much heavier. Not all units would fit and even those that do, require elaborate motions.




Sent from my Nexus 10 using Tapatalk


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group