Hobie Forums http://www.hobie.com/forums/ |
|
PA 12: Purpose of These Screws? http://www.hobie.com/forums/viewtopic.php?f=78&t=49930 |
Page 1 of 1 |
Author: | OVERBOARD [ Mon Nov 25, 2013 9:59 am ] |
Post subject: | Re: PA 12: Purpose of These Screws? |
good ?... I was wondering the same thing yesterday. |
Author: | Lt.FireDog [ Mon Nov 25, 2013 10:19 am ] |
Post subject: | Re: PA 12: Purpose of These Screws? |
They hold the structural foam in place that is in the gunnels (side). I had to back these out (screws), so I could move the foam when I mounted the YakAttack GT90 GearTracs on top of the gunnels, between the side boards & the side carry handles. |
Author: | IN2DEEP [ Mon Nov 25, 2013 11:24 pm ] |
Post subject: | Re: PA 12: Purpose of These Screws? |
Lt.FireDog wrote: They hold the structural foam in place that is in the gunnels (side). I had to back these out (screws), so I could move the foam when I mounted the YakAttack GT90 GearTracs on top of the gunnels, between the side boards & the side carry handles. Thank you so much! I might be needing to access this area in the near future |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |