Does that cause a problem when you are required to paddle or when entering the PA?
didn't seem to be a problem getting in/out.
In regards to paddling...if the need arises (ie-last resort), I can fold both mounts out of the way...but I think I'll call SeaTow
before I try to paddle any distance.
+1 on the nice setup.
Question on mounting to gunnel: Did you have to use the mounting bullets to install the fullback mounting plates, or can you position then with your hand to get the screws started?
I didn't use the YakAttack Rigging Bullets
(have them, didn't think about it
I was able to get within reach of the area (through center hatch) after removing the deck structural foam and removing the (2) screws that hold the foam in the gunnel.
I used a screwdriver (w/appropriate head), taped screw onto driver and started the screw into the backing strip...I was able to get the plate in place and started two of the screws, then backed out the one that was attached to the driver.
Not too hard a project, but good for a couple cuss-words.