need some help

I was out fishing sunday and one of the mast for the fins broke off it was my fault its been bent a few times i tryed an easy out and it wont even turn need some ideas any help would be great i have a 2014 pa14

Maybe just replace the sprocket and mast rather than struggle with it. The sprockets aren't too expensive ($18.99 USD / USA 11-2014)

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)

Thanks i was thinking the same thing but i had to try
Is that price for the mast and sprocket

Do you have enough to get a grip on? Try a little heat... NOT a torch, blow drier, heat gun...

I dont have enough to grip i might try a soldering iron in the hole i got driled in it be for i give up

I had to do this same repair a month ago and ended up doing this. A lot less hassle.

_________________
"I have always found it easier to show people what the coolest things about fishing are, rather than just tell them another fish story."
--Jose Wejebe

That is just the sprocket.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)

solder not strong enough to hold... will the EZ out bite?

Thanks for the help im just going to replace the sprocket i was just trying to keep from takeing the drive apart
And no the easy out kept slipping when i put some good pull on it its a very good set i have there from snap on tools