Hobie Cat Forums

It is currently Sun May 19, 2013 10:13 pm

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 20 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Fri Jan 15, 2010 12:21 am 
Offline
Site Rank - Captain

Joined: Wed Jan 06, 2010 1:35 am
Posts: 26
Location: Australia, Queensland
i havnt actually capsized my 14 yet.. too scared to..
everyone says they are a pain in the ass to right them..
and i dont have a righting line..
so what i have done is put a couple of foam balls on the top of my mast lol..
does anyone know how to do a makeshift right line..

im pretty sure one of my mates told me to tie a line to the dolphine striker and then throw it over the top hull..
is that right?

_________________
Image

My H14t

currently being sanded back and repainted..


Top
 Profile  
 
PostPosted: Thu Oct 07, 2010 9:05 am 
Offline
Site Rank - Deck Hand

Joined: Thu Oct 07, 2010 7:58 am
Posts: 1
On a Hobie 16, the problem arises in strong wind, shallow water, and a muddy bottom, where strong wind pressure against the bottom of the tramp can quickly drive a non-floating mast head into the soft muddy bottom, before you have a chance to right the boat, especially if you are alone, or have an inexperienced crew member-- at that point, it is impossible to extricate without the help of a powered vessel or a winch from shore, if you are close enough to shore... "Sealed" masts often aren't very watertight, and they sink pretty fast if you can't right the boat immediately. The pressure on the bottom of the tramp and the resistance of the mainsail to the direction of motion of the capsized boat as it is pushed across the surface operate to force the mast head down even faster, even when mainsail and jib are fully released. Some kind of a float might make sense if you are sailing in these special conditions... :)


Top
 Profile  
 
PostPosted: Sat Oct 09, 2010 9:04 pm 
Offline
Site Rank - Old Salt

Joined: Sat Jul 02, 2005 9:47 pm
Posts: 550
Location: San Diego
An alternative to the mast float is sail float. Some of the small boats around here that are used for lessons have a floatation pocket sewn into the head of the sail. It is a light alternative to the float. If you want it to be less permanent, sew velcro to the sail and the floatation foam pocket and take it off or place it on as needed. You don't need a large chunk of foam to make this work.


Top
 Profile  
 
PostPosted: Sat Oct 09, 2010 9:09 pm 
Offline
Site Rank - Old Salt

Joined: Sun Oct 03, 2004 8:45 pm
Posts: 602
Location: Saskatoon, Sk. Canada
You could take some 1" foam about 3 ft. long and using contact cement, attach it to the top of the mast, if you painted it flat black you would hardly know it was there. I'm note sure if that would add enough buoyancy.

_________________
06 getaway -- always remember, man with both feet in mouth have no leg to stand on.


Top
 Profile  
 
PostPosted: Sun Oct 10, 2010 7:35 am 
Offline
Site Rank - Captain

Joined: Sun Feb 17, 2008 5:17 pm
Posts: 119
Location: Saskatoon , Sk
I sail in a shallow lake with a strong current. I put a bob on my 16' and love the time it buys me. In Europe they sell long air bags that you attach to your mast. I would like to buy one for my dingy that keeps going mud hen.

_________________
I wish winter was not so long in Sask. Canada. It's hard to sail on ice! 1984 16' hobie cat Sail# 84848


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 20 posts ]  Go to page Previous  1, 2

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: sdwalleye and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group