Return to Hobie.com
Hobie Forums
It is currently Tue Apr 02, 2024 3:51 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat May 20, 2006 5:08 am 
Offline
Site Rank - Captain

Joined: Wed Jan 25, 2006 12:12 pm
Posts: 132
Location: Ibiza - Balearic Islands - Spain
Hi could someone tell me the exact measurement of a H18 tiller crossbar? and how far in the end holes for the extending castings should be?

Matt? :)

My hobie is 1981 dont know if that affects anything

Thanks


Top
 Profile  
 
 Post subject: Tiller X Bar
PostPosted: Mon May 22, 2006 4:05 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15027
Location: Oceanside, California
The tube should be about 76". The extenders on each side are about an inch minimum to about 3 inches extended on each end. Just put the rudders down. Measure to get them parallel. That is the needed length.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group