| Hobie Forums http://www.hobie.com/forums/ |
|
| Lining up the mast step pin http://www.hobie.com/forums/viewtopic.php?f=9&t=562 |
Page 1 of 1 |
| Author: | Alnorman [ Mon Nov 17, 2003 7:33 pm ] |
| Post subject: | Lining up the mast step pin |
I have a Hobie Magnum and the mast seems to sit about 1/16 or 1/8 lower than it should so that the mast step pin will pass cleanly through the hole in the hinge. Could I be missing a plastic washer that would raise the mast base hinge enough to get the pin through? |
|
| Author: | sunjammers [ Mon Nov 17, 2003 9:50 pm ] |
| Post subject: | |
Yes, there is a washer that is supposed to be under the mast step ball. Thanks, Brad Stephens Authorized Hobie/Vanguard Dealer www.sunjammers.com [email protected] 850-235-2281 Panama City Beach, FL |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|