sunEsailor - I was looking at your cart design and after reading other post about the Trailex trailer accomodating the TI, is there anyway that your cart having a TI cradle could be added to the back rail of the Trailex to become a 3rd support??
I saw a cement block truck that had its forklift attached to the back of the truck ready to go once at the worksite. Could the same be done to the Trailex trailer???
Have the 2 cradles attached to the Trailex but if the rails could be extended aft that you could then attach/clip or cambuckle your custom crossbar w/ cradle across the back rails for not only storage but also additional support for the hull?
I was thinking that once you arrived at a launch site, you could disconnect the cart and pull the TI aft off the trailer onto the cart, grab the hold straps and continue walking to the water, or if there is a good boat ramp then backup the entire trailer into the water to launch the TI? Whaddaya think??? I guess from looking at the Trailex fotos that it would take an extension of the siderails extending aft with the single, centerline rail extending beyond it to support the boat by the rudder and having a lisc plate holder and lites. Hope this helps...