Hobie Cat Forums

It is currently Thu Jul 24, 2014 7:15 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Mon Jul 18, 2011 2:06 pm 
Offline
Site Rank - Deck Hand

Joined: Mon May 30, 2011 1:08 pm
Posts: 14
My tiller crossbar endcaps have an integral bolt instead of the connection kit shown in the 2011 catalog. (The tiller tube endcaps match the catalog and are in good condition).

The crossbar endcaps are pretty chewed up and I would like to replace them. The crossbar is 76-1/8" long.

What parts are included in the RUDDER ADJUSTER KIT - 60400011?

If I get this kit (60400011) and the TILLER CONNECTOR KIT - 11520005, will I have everything I need to replace the tiller crossbar endcaps and be able to make adjustments?

How far into the crossbar do the do the endcaps insert?

Thanks.


Top
 Profile  
 
PostPosted: Mon Jul 18, 2011 2:32 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 8893
Location: Oceanside, California
The older style end caps which use a bolt, washers, spring and a nut to connect to the tiller arms are the 60400010 (x2)

This kit has the aluminum end fitting which is adjustable for toe in. It uses a short bolt and a nut which is inside the tube. Both included. I'd guess that the part inside the tube is about 4" long.

The preferred connector kit is # 3052 (shown on page 21 / 2011 Spring catalog)

_________________
Matt Miller
Director of Parts and Accessory Sales
Hobie Cat USA


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group