Hobie Cat Forums

It is currently Thu Oct 02, 2014 1:28 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Sun Jul 23, 2006 8:31 pm 
Offline
Site Rank - Admiral

Joined: Fri Jul 21, 2006 2:02 pm
Posts: 287
Location: SJ, PUERTO RICO
Hi, Anyone has a lenght wise cut away view or diagram of a H16 hull??

I need to know how deep into the hull are the pylons installed at factory and what is supporting them at the keel inside the hull.

One of my decks depressed/flexed down around the base of the pylon! Before I cut and access hole on the side of the hull I need to know this.

thanks!


Top
 Profile  
 
 Post subject:
PostPosted: Mon Jul 24, 2006 7:12 am 
Offline
Hobie Approved Guru

Joined: Mon Jul 14, 2003 7:11 pm
Posts: 4613
Location: Detroit, MI
These are on the site http://www.thebeachcats.com under "Pictures", "Technical", "Inside the Hobie 16"

Image


Top
 Profile  
 
PostPosted: Fri Sep 16, 2011 7:53 pm 
Offline
Site Rank - Deck Hand

Joined: Fri Sep 16, 2011 7:32 pm
Posts: 2
This compression point seems to be the source of continuous hull cracking.
How about an injection of a high density closed cell foam around this point to distribute the loads more evenly?
Access is the problem too.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group