Hobie Cat Forums

It is currently Sun Oct 26, 2014 1:12 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Aug 02, 2012 1:41 pm 
Offline
Site Rank - Captain

Joined: Fri Jun 05, 2009 7:44 am
Posts: 65
Location: Philadelphia, PA
I've purchased a later mod of the forward cross bar--the one where the plate extending forward with the plastic ball bearings in it is inserted into the Xbar and welded twice. I've also just read about the internal trusses tearing out of the hull.

Can anyone direct me to threads with tips or experience on replacing this Xbar and making sure the trusses are tuned properly inside the hull? Or, if no threads exist, can anyone offer any advice about this??

Going away with the boat in a week, and would like to feel safe in rougher conditions. Thanks!


Top
 Profile  
 
PostPosted: Fri Aug 03, 2012 4:11 am 
Offline
Site Rank - Old Salt

Joined: Thu Aug 16, 2007 2:25 pm
Posts: 2036
Location: Central Coast NSW Australia
You might find this helpful:

http://2010.archive.hobiecat.com/suppor ... 50X001.pdf


Top
 Profile  
 
PostPosted: Sat Aug 04, 2012 8:27 am 
Offline
Site Rank - Captain

Joined: Fri Jun 05, 2009 7:44 am
Posts: 65
Location: Philadelphia, PA
Thanks, Stringy... Starting that job today... :-)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group