I've sorted through my Hobie Spinnaker hardware kit and it seems to be in order as to where almost all parts should go and their purposes.
However there are two parts that seem to mystify me as to where they should be installed due to lack of supplied instructions:
1) The large white plastic washer.
2) The single rivet with the black mandrel with the 'PH' code ending.
As there is no video footage available for a standard Hobie Spinnaker Hardware Kit install, I will try to answer any questions with photos if needed by anyone in the same position as myself after I'm finished with the install (and my own mods that I can already see before I even start this project).
Please keep in mind that I will also add a traveller kit and a Cheata Motor mount for a Torqeedo 1003 short shaft electric outboard motor on this 2010 Wave CE.
Any help will gain you Karma points, (I hope)
Thanks for any insight friends.