Pin hole in Adventure Hull

Just took delivery on 07 Adventure and was doing some rigging and loose plastic clean up. Noticed a pin hole at the rear of the dagger board slot right where it joins the the bottom. Haven't had the hull in the water yet but am sure it will leak. Any suggestions patching or should I just take it back to the dealer? I have already mounted a flag on the stern deck and a eye in front of the peddals to put a teather on. Thanks for the input. I am going to post this on the Hobie formum on KFS too. Mike

_________________
I haven't had this much fun since the pigs ate my baby sister.

Pin hole? Could be a little bubble, but certainly, if it is a leak point, take it back to the dealer for review. This may be easily corrected or replaced if needed.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)