You will get some water but not more than 1 or 2 cups. I think the rudder line holes are the cause because the outfitter rear is very low. They spend lots of time under water especially if you are on a heavy side
You can check your hatches leak by put a towel under it and spay water on top (if leak then check for the rubber ring and make sure it straight all around or could be debris).
I don't think this model has issue with crack on the drive well(s) even older model year but you should check it out. Visually or you could fill water half way in the hull and check for any leak.
Use towel if not much water and if lots of water then put it up side down and have the back of your yak on the higher side (have the cooler or something support it). Most of time I just lean the yak on the side and use a cup to get the water out (I don't use pump pile - too much exercise).