Return to Hobie.com
Hobie Forums
It is currently Fri Apr 19, 2024 1:55 pm

Board index » Hobie Catamaran Sailing » Hobie 20

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
benskiing
PostPosted: Fri Jun 01, 2007 11:16 am 
Offline
Site Rank - Captain

Joined: Thu Mar 24, 2005 11:20 am
Posts: 43
Location: usa
I am ready to rivet all my 20 parts on my new extrusion.
And my old mast is bent like a wet noodle. I am looking for the drill distances up the mast. especially the diamond wire points and upper diamond wire mounts. Also the cut length for a hobie 20 mast prior to comptip installation.
The donor mast is a h18 all alluminum extrusion.

Can anyone email me working drawings. or specs?
thanks
ben
[email protected]
Top
 Profile  
 
mmiller
 Post subject: Drawings
PostPosted: Fri Jun 08, 2007 9:41 am 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15035
Location: Oceanside, California
Unfortunately drawings are not available for distribution from Hobie Cat. You would have to take the measurements off your old mast.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Hobie Catamaran Sailing » Hobie 20

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group