Return to Hobie.com
Hobie Forums
It is currently Fri Mar 29, 2024 7:32 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Nov 07, 2004 6:26 pm 
Offline
Site Rank - Deck Hand

Joined: Sun Nov 07, 2004 6:04 pm
Posts: 1
Looking for suggestions on replacing the traveler on a H-20. I have ordered a replacement traveler. Do I need to remove the rivets on one of the rear crossbar end caps?


Top
 Profile  
 
 Post subject: H20 Traveler
PostPosted: Sun Nov 07, 2004 11:06 pm 
Offline
Site Admin

Joined: Tue May 27, 2003 12:44 pm
Posts: 15027
Location: Oceanside, California
H20 Traveler replacement.

You must remove one of the track-end stops. The boat came with a "loader" typically a short plastic section of track (blue). The old car is slid onto the loader and then the traveler bearing balls are collected. Place the new car on the loader and them "load" the bearing balls into the loader and new car. Line up the loader / car with the track and slide onto the track. Fasten the end cap again.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group